In the design of hydraulic valve block, the oil circuit should be as simple as possible, and the deep hole, inclined hole and process hole should be reduced as much as possible.

Clean the valve block. Remove all kinds of particle pollutants, corrosives, grease, etc. on the surface of valve block. In order to ensure that the valve block will not rust prematurely in use, it is necessary to carry out antirust treatment.

If the number of hydraulic components on a certain surface of the hydraulic valve block is not more than 8, other hydraulic components can be arranged near the four sides according to the situation, except that the hydraulic components are arranged near the four corners. This ensures that the process holes are designed near one or two edges.

Material selection: different materials determine different pressure levels. First of all, reasonable material selection should be made according to the use pressure. Generally speaking, the following principles should be followed: when the working pressure P < 6.3MPa, cast iron HT20-40 can be used for hydraulic valve block.

The design of hydraulic valve block mostly belongs to non-standard design, which needs targeted design according to different working conditions and use requirements. The design of valve block is roughly divided into the following steps: material selection, processing and heat treatment, deburring and cleaning, surface anti rust treatment and test.